Titration Parameters - Xylem SI Analytics TitroLine 5000 Operating Manual

Titration parameters

4.6.4
The «Titration parameter» submenu is used to determine the actual parameters of the method (Fig. 87 and Fig.
88).
Fig. 87
Fig. 88
4.6.4.1 Generally applicable titration parameters
Depending on the titration mode (dynamic, linear, End-Point titration), it is possible to enter a variety of
parameters.
The following parameters are valid for all automatic titration modes:

Measured value (pH and mV)

Measurement speed

Initial waiting time

Pre-titration

Titration end
The measurement speed and the titration end differ again as a function of the respective titration mode.
The «Measured value» is the first selection to be made, e.g. «pH» (Fig. 89).
Fig. 89
123