Before Connecting The Opc-2357 To The Pc; Connecting With Pc - Icom IC-SAT100M Network Setting Manual

Before connecting the OPC-2357 to the PC

To use the OPC-2357 PROGRAMMING CABLE, you must first install a USB driver.
The driver and installation guide are supplied with the programming cable.
Read the guide carefully before installing the driver.

Connecting with PC

1. Be sure the transceiver is OFF, and Windows has completed its startup.
2. Connect the cable, as shown below.
3. Turn ON the transceiver.
Default
IP address:
Subnet Mask:
Default Gateway: 192.168.0.254
192.168.0.1 (Main Unit)
192.168.0.2 (Antenna Unit)
255.255.255.0
To the D-Sub 25-pin
connector
OPC-2357
Turn OFF
Microphone
Main Unit
192.168.0.1
PC
3
Antenna Unit
192.168.0.2
To a USB
connector