Huffy Portable Basketball System Owner's Manual page 24

SECTION E: APPLY HEIGHT AND MOVING LABEL
Apply Moving Label (15) to front of pole, where it is clearly visible.
1.
P/N 211472 05/04
Size = 4" x 3"
HEIGHT ADJUSTMENT
Corner Radius = 3/8"
MOVING SYSTEM
Size = 4" x 5.5" Die Cut Label
TO ADJUST BACKBOARD: Corner Radius = 3/8" 3.25 Mil Vinyl
Die Cut Label All Temp. Permanent Adhesive
Position looped end of crank Height
1. While holding pole, rotate Indicator
onto hook as shown. Rotate basketball system forward 3.25 Mil Vinyl 1 Mil. Polypropolyne Overlaminate
until wheels engage with
crank handle to raise or lower ground. All Temp. Permanent Adhesive
Illustrator 8.0 = EPS
backboard.
2. Move basketball system to Crank 1 Mil. Polypropolyne Overlaminate
desired location. Hook Backing + 1/16 Circumference
1 3. Carefully rotate basketball Illustrator 8.0 = EPS
Rolls of 500
2 system upright.
MOVING SYSTEM Backing + 1/16 Circumference
3 4. Reattach ground restraint and
check system for stability.
Rolls of 500
1. Adjust basketball backboard 201261 3/99
height to lowest position.
1
2. Rotate basketball system
forward, while holding pole,
until wheels engage with
ground.
3. Move basketball system to
2 desired location.
4. Carefully rotate basketball
3
system upright.
4
5. Reattach ground restraint and
check system for stability.
201254 2/99
DIRECT MOUNT & EXT. ARM
PORTABLE
Eng: Dan\Tom SURE SHOT - 748
U-TURN : ADJUSTMENT
1st Used: 201261 PORTABLE
Eng: Dan\Tom
3/99 1st Used: 201254
2/99
Eng: Dan\Tom
1st Used:
2/99
24
HEIGHT ADJUSTMENT
TO ADJUST BACKBOARD:
Position looped end of crank
onto hook as shown. Rotate
crank handle to raise or lower
backboard.
MOVING SYSTEM
1. Adjust basketball backboard
1 height to lowest position.
2. Rotate basketball system
forward, while holding pole,
until wheels engage with
ground.
3. Move basketball system to
desired location.
2
4. Carefully rotate basketball
3
system upright.
4
5. Reattach ground restraint and
check system for stability.
15
Height
Indicator
Hook Crank
201254 2/99