1. Manuals
  2. Brands
  3. Huffy Manuals
  4. Sports & Outdoors
  5. Single Electronic Basketball System
  6. Owner's manual

Huffy Portable Basketball System Owner's Manual

Hide thumbs Also See for Portable Basketball System:
Table of Contents

Advertisement

Quick Links

Download this manual
WARNING!
READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE USING THIS UNIT.
FAILURE TO FOLLOW
OPERATING INSTRUCTIONS
COULD RESULT IN INJURY
OR DAMAGE TO
PROPERTY.
© COPYRIGHT 2004 by HUFFY SPORTS
Portable Basketball System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
• 2 People
• Tape Measure
• Wood Board (scrap)
• Sawhorse or
Support Table
• Hammer
• Step Ladder 8 ft. (2.4m)
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-333 061
Internet Address: http://www.huffysports.com
REQUIRED TOOLS AND MATERIALS:
• (2 each) Wrenches and/or
Socket Wrenches and
Sockets (Deep-Well Sockets
are Recommended).
7/16"
1/2"
AND/OR
7/16"
1/2"
• Extension is Required.
1
• Garden Hose or
Sand
9/16"
3/4"
• Optional: Large &
Small Adjustable
Wrenches
9/16"
3/4"
05/04
P/N 211472

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Portable Basketball System and is the answer not in the manual?

Questions and answers

Related Manuals for Huffy Portable Basketball System

Summary of Contents for Huffy Portable Basketball System

  • Page 1 • Extension is Required. Toll-Free Customer Service Number for U.S: 1-800-558-5234, For Canada: 1-800-284-8339, For Europe: 00 800 555 85234 (Sweden: 009 555 85234), For Australia: 1-800-333 061 Internet Address: http://www.huffysports.com 05/04 P/N 211472 © COPYRIGHT 2004 by HUFFY SPORTS...
  • Page 2 FRANÇAIS DEUTSCH ESPAÑOL ITALIANO Système portable Manuel d'utilisation AVERTISSEMENT ! WARNUNG! Service clientèle ¡ADVERTENCIA! o N53 W24700 South Corporate Circle o Sussex, WI 53089 o É.-U. LISEZ LE MODE D'EMPLOI AVANT D'UTILISER CE SYSTÈME SOUS PEINE D'ENCOURIR DES BLESSURES Tragbares System OU DES DÉGÂTS MATÉRIELS.
  • Page 3 NEED TRANSLATION PUT IN 05/04 P/N 211472...

  • Page 4: Safety Instructions

    Use caution when using this unit. NOTICE TO ASSEMBLERS ALL Huffy Sports basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.
  • Page 5 Get to know the basic parts of your basketball system..FRONT BACK BACKBOARD ELEVATOR ASSEMBLY TOP POLE MIDDLE POLE STRUTS BOTTOM POLE BASE WHEEL CARRIAGE ASSEMBLY 05/04 P/N 211472...
  • Page 6 PARTS LIST (See Hardware Identifier) Item Qty. Part No. Description 206647 Tank (Black) 200628 Wheel Axle 226401 Wheel 908136 Top Pole Section 908077 Middle Pole Section with Label 905840 Bottom Pole Section 202820 Rod, 3/8 O.D. x 4-3/4 Long 202822 Eye Bolt, 3/8 x 16 x 3-3/4 Long 202821 Disk, 2.75 O.D.
  • Page 7 HARDWARE IDENTIFIER (BOLTS) Item #11 (1) Item #23 (1) Item #8 (1) Item #22 (4) Item #37 (4) Item #7 (1) HARDWARE IDENTIFIER (NUTS & WASHERS) Item #14 (1) Item #17 (8) Item #35 (7) Item #10 (1) Item #21 (18) Item #27 (4) Item #9 (5) HARDWARE IDENTIFIER (OTHER)
  • Page 8 SECTION A: ASSEMBLE THE POLES Correctly identify each pole section. POLE IDENTIFICATION MIDDLE MARK BOTTOM WARNING LABEL Bounce pole top (4) and middle section (5) together as shown until they no longer move toward pole identification mark. Upright assembly. NOTE: POLE SECTIONS SHOULD HAVE A 3-1/2"...
  • Page 9 Bounce top and middle pole assembly and bottom pole (6) together as shown until they no longer move toward pole identification mark. NOTE: IMPORTANT!: Holes in top (1) and POLE SECTIONS SHOULD HAVE A bottom pole (3) sections 3-1/2" (9 CM) MINIMUM MUST align to correctly OVERLAP.

  • Page 10: Section B: Assemble The Base

    SECTION B: ASSEMBLE THE BASE This is what your system will look like when you’ve finished this section: HARDWARE USED IN THIS SECTION TOOLS REQUIRED FOR THIS SECTION (not actual size) 9/16” and 1/2” Item #7 Item #8 Item #11 Item #10 203063 Hex Locknut (Nylon Insert) Item #27...
  • Page 11 Install rod (7) through holes in bottom pole (6) section and eyebolt (8). h03.EPS Install wheel axle (2) through support foot (24) and install wheels (3) onto wheel axle (2) with spacers (27) as shown. 05/04 P/N 211472...
  • Page 12 Insert pole assembly into tank assembly as shown.Secure pole assembly to tank and wheel bracket as shown. Note orientation of support foot. WARNING! TWO PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

  • Page 13: Top View

    Secure tank struts (12 & 13) to pole. Nut (14) should be tightened until flush (even) with locknuts outer edge. TOP VIEW WARNING! TIGHTEN BOLT (11) IN LOCK NUT (14) UNTIL FLUSH (EVEN) WITH LOCK NUT’S OUTER EDGE. 05/04 P/N 211472...
  • Page 14 Rotate all non-secured ends of tank struts to mounting holes in tank as shown. Secure non-secured ends of tank struts to tank as shown. P/N 211472 05/04...
  • Page 15 SECTION C: ASSEMBLE THE BACKBOARD This is what your system will look like when you’ve finished this section: TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION 1/2” Item #10 Item #35 Item #21 Item #33 Item #38 Item #37 1/2”...

  • Page 16: Front Of System

    Install screw jack support plates (29 & 30) to TOP VIEW pole using bolts (32) washers (31) and (35) as shown. FRONT OF SYSTEM FRONT OF SYSTEM P/N 211472 05/04...
  • Page 17 Attach height decal (31) to screw jack (36). Align lower edge of decal with bottom of black indicator tube. Center screw jack (35) between jack plates (29 & 30)) and secure as shown below. Do not overtighten. FRONT VIEW OF ASSEMBLY IMPORTANT!: DO NOT OVER 2.4m...
  • Page 18 Secure upper elevator tubes (33) to pole assembly as shown. IMPORTANT!: DO NOT OVER TIGHTEN Insert spacer (39) through top holes of height indicator cover (41) and screw jack assembly as shown. Align spacer (39) and screw jack assembly between elevator tubes (33) and secure.
  • Page 19 Assemble backboard brackets (20) using spacers (16) bolts (22) and nuts (10) as shown. Add reinforcement spacers (38) to bpard brackets (20) in locations shown. Refer To Instructions Included With Rim Hardware For Rim Assembly. 05/04 P/N 211472...
  • Page 20 Assemble backboard to elevator tubes (33 & 34) as shown. WARNING! TWO PEOPLE REQUIRED STRAIGHT ON VIEW FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. WARNING! DO NOT LEAVE ASSEMBLY UNATTENDED WHEN EMPTY; IT MAY TIP OVER.
  • Page 21 Install clips. WARNING! CLIP “ARM” USE OF THIS PRODUCT WITHOUT PROPER INSTALLATION OF SMART CLIPS ® , OR WHEN ALL SMART CLIPS ® ARE NOT PRESENT COULD RESULT IN BODILY HARM. BE SURE TO FOLLOW DIRECTIONS CAREFULLY. CLIP “BODY” Insert one “arm” of clip into ram as shown. Twist “body” of clip slightly so that second “arm”...
  • Page 22 NET INSTALLATION SIDE VIEW NETCLIP Insert net into bottom of clip as shown. SIDE VIEW Twist net until it snaps into position. Net must be centered through clip. NETCLIP P/N 211472 05/04...

  • Page 23: Section D: Securing The System

    SECTION D: SECURING THE SYSTEM Place assembled unit to desired location. Fill tank with water (28 gallons (114 liters)) or sand (360 lb. (163 kg)) and snap tank cap (28) in place. CAUTION! ADD TWO GALLONS (7.6 LITERS) OF NON-TOXIC ANTIFREEZE IN SUB- FREEZING CLIMATES.
  • Page 24 SECTION E: APPLY HEIGHT AND MOVING LABEL Apply Moving Label (15) to front of pole, where it is clearly visible. HEIGHT ADJUSTMENT TO ADJUST BACKBOARD: Height Position looped end of crank Indicator onto hook as shown. Rotate crank handle to raise or lower backboard.

  • Page 25: Section G: Height Adjustment

    SECTION G: HEIGHT ADJUSTMENT WARNING! Position looped end of height adjustment crank (42) onto hook as shown. Rotate crank handle STORE CRANK OUT OF to raise or lower backboard. View label (31) to REACH OF CHILDREN. determine approximate backboard height. DO NOT ALLOW CHILDREN TO ADJUST NOTE: If height adjustment is difficult to...

Table of Contents