Download Print this page
Front Runner FAJK002 Start Here Manual
Hide thumbs Also See for FAJK002:

Advertisement

Quick Links

START HERE!
Don't be a hero and muscle through this without first reading these fitting instructions! Improper installation of this gear may void certain aspects of
your warranty.
Before you begin, take a moment and open all your Front Runner rack kit boxes and gather the assembly instructions for the various components.
A complete kit will contain:
1. A Front Runner Mounting System specific to your vehicle
2. A Front Runner Rack Tray or Load Bar Slats
This document will guide you through the assembly of the mounting system and assist you in fitting the roof rack tray or load bars to your specific
vehicle.
Please refer to the next page for a list of all the components, quantities and tools required.
FRONT RUNNER CAN NOT RECOMMEND A MAXIMUM LOAD CARRYING CAPACITY. PLEASE REFER TO YOUR VEHICLE MANUFACTURER'S RECOMMENDATIONS. IT IS CRITICAL
THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN
AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS
TO YOUR VEHICLE. CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND DAMAGE. THEREFORE YOU
MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU
DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE
INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
FAJK002 / FAJK006_REV_C00
inner brackets and Foot Rail
Jeep Wrangler JKU 4 Door (2007-Current)
READ ME FIRST
IMPORTANT WARNING!
1
© COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS
ENG
FAJK002 / FAJK006
180 min

Advertisement

loading
Need help?

Need help?

Do you have a question about the FAJK002 and is the answer not in the manual?

Questions and answers

Summary of Contents for Front Runner FAJK002

  • Page 1 Don’t be a hero and muscle through this without first reading these fitting instructions! Improper installation of this gear may void certain aspects of your warranty. Before you begin, take a moment and open all your Front Runner rack kit boxes and gather the assembly instructions for the various components. A complete kit will contain: 1.
  • Page 2: Tools Needed

    M6 x 19 x 1SS Flat Washer Rear Support Bracket - 1LH + 1RH M8 x 75 Hex Bolt M8 Large Washer Middle Support Bracket - 1LH + 1RH 16 X Sealing Plug Assembly FIGURE 1.1 FAJK002 / FAJK006_REV_C00 © COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 3 M8 X 16 Hex Bolt Foot Rail - 1LH + 1RH 14 X M8 x 16 x 1.6SS Flat Washer 14 X M8 Nyloc Nut 14 X M8 Nut Cap FIGURE 1.2 FAJK002 / FAJK006_REV_C00 © COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 4 PREP FOR INSTALLATION OF INNER BRACKETS (FAJK002) Loosen velcro, unzip and remove the padding covering the roll bars. Remove the wiring harness and plastic clip from the roll bar. Locate the two threaded holes on the underside of the roll bar and fasten the two halves of the Roll Bar Clamps (Items 1 &...
  • Page 5 From outside the vehicle, using your 6mm drill bit, drill the four pilot holes through the marks you just made. Repeat Step 2.1 to 3.3 for the opposite 10mm side. 13mm FAJK002 / FAJK006_REV_C00 © COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 6 Pull back the padding around the roll bar above the rear seats and insert an M8 x 75 Hex Bolt and M8 Large Washer (Items 12 & 13 from FAJK002 box) through the hole as shown. From the inside of the vehicle, in the same position as where you just inserted the bolt in Step 3.5, push the...
  • Page 7 Bolts (Item 16 from FAJK006) or (Item 1 from FAJK003) into the first slat (Combined Slat), using the Machined slots. Slide a bolt to each 13mm of the outer corners. FAJK002 / FAJK006_REV_C00 © COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 8 M6 x 19 x 1SS Flat Washers, M6 x 30 (Items 3, 6, 7 & 10 from FAJK002 box). Centre the tray from left to right. Use a tape measure to double check. Once you are happy that...
  • Page 9 After your first adventure, check that all nuts, bolts, screws and fittings are tight. Re-tighten where needed. You'll find a small amount of settling has happened. Go on many more adventures, periodically checking all nuts, bolts, screws and fittings. Front Runner can not recommend a maximum load carrying capacity. Please refer to your vehicle manufacturer's recommendations FAJK002 / FAJK006_REV_C00...
  • Page 10 Congratulations. You did it. Take a step back and admire your work! INSTALL OTHER VEHICLE AND RACK ACCESSORIES Now's the time to visit your favorite Front Runner Dealer in person or online. FAJK002 / FAJK006_REV_C00 © COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS...

This manual is also suitable for:

Fajk006