Table of Contents
Advertisement
10.3. Fault displays
The component does not have a direct user interface. A status LED on the circuit
board of the component indicates the operating status during operation of the
blueplanet hybrid inverter.
Operating status display
Red = there is a malfunction
Cause/solution:
1.
Check the wiring to the inverter.
a.
Is the cable damaged?
b. Are the plugs mounted correctly?
c.
Cable type: CAT 5E S/FTP, no cross-over
d. Is the cable length at most approx. 20 m?
Test another communication cable, if available.
2.
Check the correct connection to the grid and the correct earthing of
the component.
Off = no/insufficient power supply
The blueplanet hybrid inverter supplies the component with power via the communication
cable.
Cause/solution:
1.
The blueplanet hybrid inverter is not in operation.
2.
The wiring to the inverter is interrupted.
Error output via the inverter
Warning and error messages of the component can also be output via the connected
blueplanet hybrid inverter and the associated hy-sys software. These are
documented in the operating manual of the blueplanet hybrid inverter.
hy-switch for KACO blueplanet hybrid inverters
Page 29
Advertisement
Table of Contents
Troubleshooting
