Table of Contents
Advertisement
9.
Operation
9.1.
General information
The component does not have a direct user interface. A status LED on the circuit
board of the component indicates the operating status during operation of the
blueplanet hybrid inverter.
Operating status display
Green = component is ready for operation
Red = there is a malfunction
Off = no/insufficient power supply
9.2.
Selecting the current sensors
The component offers the possibility to use internal and external current sensors.
Depending on the configuration, different functions and different maximum
currents can be measured (see 8.2).
The current sensors can be selected on the blueplanet hybrid inverter via the user
interface or the hy-sys software. For more information, please refer to the operating
instructions of the inverter and the application note for the hy- sys software.
9.3.
Firmware updates
The firmware of the component should be updated regularly. The update is
carried out via the hy-sys software. This must be run on a computer connected
to the blueplanet hybrid inverter.
The current firmware version can be found in the download area of the KACO
homepage, under
extension .EDU is required for the firmware update. Details on updating the firmware
can be found in the hy-sys software application note in the Update section.
hy-switch for KACO blueplanet hybrid inverters
www.kaco-newenergy.de
A special update file with the file
Page 27
Advertisement
Table of Contents
Troubleshooting
