Start-Up - Kaco blueplanet hy-switch Operating Instructions Manual

Fig. 10: External component connections for the external current sensors (jack plug) and the
8.5. Commissioning
The component is set to switch through grid and off-grid side of the connections in
the delivery state. The component is activated when the blueplanet hybrid inverter
is started. This can also be used to make settings on the component, e.g. the
selection of the current sensors. Please refer to the manual of the blueplanet hybrid
inverter.
The component is ready for operation when the green LED on the circuit board lights
up.
Check whether the current firmware version is installed and update it if necessary.
For more information, see 9.3.
26
Page
Communication RS485
external current sensor L3
external current sensor L2
external current sensor L1
communication cable (RJ45)
hy-switch for KACO blueplanet hybrid inverters