Kaco blueplanet hy-switch Operating Instructions Manual page 24

3.
4.
5.
8. If you want to use external current sensors, install them and connect the
cables to the CS connections on the side: L1, L2, L3 (see Fig. 10).
9. Check that the phases or current sensors are connected to the
component in the correct order.
10. Check all cables for firm fit.
11. Hold the cover plate on the mounted housing and carefully engage the
upper and lower plastic hinges. The component must be securely closed
with this.
12. Switch the grid connection back on.
» Component is mounted next to the switch box/control cabinet on the wall.
24
Page
Connect the house grid (consumer) to "off-grid" (3p+N)
and connect to the corresponding connection point in the
control cabinet.
(only when using the component's internal current
sensors)
Connect the grid connection to "grid" (3p+N) and
connect to the corresponding connection point in
the control cabinet.
Carefully close the cable gland [
hy-switch for KACO blueplanet hybrid inverters
W_36].