Page 1
Dyness Battery System QUICK INSTALLATION GUIDE Tower T Series-T7/T10/T14/T17/T21 File version-20221018-V1-EN information might be subject to change without notice during product improving. V1.0...
Target Group Skilled personnel recognized This manual and the tasks and procedures described herein are intended for use by skilled workers only. A skilled worker is defined as a trained and qualified electrician or installer who has all of the following skills and expenence: •...
Page 3
Packing list Item Specification Quantity Figure Standard, Black Communication Cable to Inverter 1 PCS /L2000mm /RJ45 plug at both sides Communication Connector to BDU RJ45 Waterproof connector 1 PCS M4 12pcs M4*12 12PCS M6 3 Sets of Combined Screws M6×2pcs 2 PCS OT terminal for Ground OT4-6...
Page 4
Balance Unpack Separate the BDU and Base BDU+Base D1=50cm HV9637 D2=30cm Stacking and locking Connect the cable Earth connection Note: When assembling the BDU, Communication cable ensure that the circuit breaker 10±0.5mm switch of the BDU is in the "OFF" state.
Page 5
Press and hold the "WAKE" button 3 ~ 7secs. Parallel system Dyness supports the maximum 12 cluster and machine use, it needs to configure a dedicated flow box.
Page 6
KOSTAL PLENTICORE PLUS KOSTAL PLENTICORE PLUS WH/OG Standard network cable, cut off one side. Tower T series Communication Cable Connection Ingeteam (INGECON SUN STORAGE1 PLAY TL M) Ingeteam (INGECON SUN STORAGE1 PLAY TL M) WH/BU Standard network cable, cut off one side.
Page 7
Goodwe ET Inverter Dyness has a standard communication network cable. It is recommended to use the GW configuration network cable and directly connect to the CAN port of the battery BDU. The 2 terminals are the Ethernet cable of the RJ45 terminal.
Page 8
Power You Day and Night Official Website Digital version access DYNESS RENEWABLE ENERGY GROUP CO., LTD. www.dyness-tech.com...
Need help?
Do you have a question about the Tower T Series and is the answer not in the manual?
Questions and answers