CHIEF MSP-KTPHD Series Quick Start Manual

M S P - K T P H D - X X Q U I C K S T A R T G U I D E
WARNING:
Exceeding the weight capacity
can result in serious personal injury or
damage to equipment! It is the installer's
responsibility to make sure the combined
weight of all components attached to the
MSP-KTPHD-XX up to (and including) the
display does not exceed 35 lbs (15.87 kg) per
interface..
This Quick Start Guide is meant to provide only an overview of the various installation steps.
ALWAYS read the Installation Instructions for each individual product within this kit before
beginning the Installation.
1a
Pole Attachment for MSP-KTPHD-FS - Assemble pole
to base using one 3/8-16 x 1" flat head cap screw.
pole
base
Pole attachment for MSP-
1c
KTPHD-DC NOTE: In order
to reduce the chance of
scratching to the mounting
surface, bumpers may be
installed. However,
installation of bumpers is
optional.
Remove adhesive from
underside of bumpers.
Attach bumpers to underside
of desk clamp.
Use 7/32" hex key to install
3/8-16 x 1" flat head cap
screw through the opening
on top of desk clamp and
into bottom of mounting pole
MSP-KTPHD-FS
3/8 x 16 x 1" screw
desk clamp
3/8 x 16 x 1"
bumpers
pole
MSP-KTPHD-GM
Pole attachment for MSP-KTPHD-GM -Locate desired point on
1b
surface where mount is to be installed. Drill a 1/2" diameter hole
through surface. Align grommet mount base plates with hole in
surface. Slide one 3/8-16 x 6" hex head cap screw upward
through lower grommet plate, through hole in surface and through
upper grommet plate. Place pole, provided with array accessory,
onto upper grommet plate aligning threaded hole in pole bottom
with threaded end of 3/8-16 x 6" hex head cap screw. Thread 3/8-
16 x 6" hex head cap screw into pole bottom and tighten with 9/16"
wrench to secure pole and grommet plates to surface.
pole
lower grommet plate
Place desk clamp over desired mounting location on desk.
Turn clamp screw until the clamp is secured to the desk as tightly
as possible.
MSP-KTPHD-DC
upper grommet plate
3/8-16 x 6" screw
clamp screw