KwikGoal 2B2201 Assembly Instructions

Project strikeforce

Assembly Instructions FOR 2B2201 (PROJECT STRIKEFORCE)

1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,

notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or

damp packaging may damage contents.

2. Read through entire instruction before beginning assembly and installation.

Parts

Base (2)

(Part# UZ480S)

This goal has been designed to be used for the game of soccer only. Goal posts must be anchored AT ALL TIMES

and shall be secured against overturning. Do not climb on the net or goal framework at any time! All fastenings

must be checked to insure they are fully tightened before and after each use of this product. Goal posts not in use

must be disassembled and properly stored in a safe, secure area (See included Guidelines for Movable Soccer Goal

Safety.). Assembled goal posts should not be left unattended. Remove nets when goals are not in use. Do not use

this equipment during the threat of high winds. Goal posts should be checked for safety before and after each use.

All warning and safety labels included with this product must be visible at all times.

Any modifications to this or any Kwik Goal product will void any and all warranties.

Post (2)

(Part# UZ481S)

Net (1)

(Part# 3B3041)

140 Pacific Drive Quakertown, PA 18951

800-531-4252 Kwikgoal.com

2002, Rev 2022 Kwik Goal Ltd.

***CAUTION***

Crossbar (2)

(Part# UZ479S)

Ground Anchor (4)

(Part# 10B1201 Pack of 4)

NZ186 Rev. 10/14/22

Table of Contents

Need help?

Do you have a question about the 2B2201 and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS FOR 2B2201 (PROJECT STRIKEFORCE) 1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred, notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or damp packaging may damage contents.
Page 2 3. Assemble crossbars, base and post as shown. Crossbar Post PUSH Base Crossbar 4. Weave assembled parts onto net as shown. Be sure to note the location of the top corner net tag. Crossbar Post Top Corner Net Tag 5. Connect crossbars, posts and bases as shown. Base Crossbar Post...
Page 3 6. Weave base through net and attach to crossbar as shown for both bases. Post Base Base Crossbar 7. Disconnect post from goal and weave through net as shown. Reconnect post to base and crossbar as shown. Repeat for other side. Post Crossbar Post...
Page 4 Anchor Ground Anchor Go to kwikgoal.com for additional product information. ***CAUTION*** This goal has been designed to be used for the game of soccer only. Goal posts must be anchored AT ALL TIMES and shall be secured against overturning. Do not climb on the net or goal framework at any time! All fastenings must be checked to insure they are fully tightened before and after each use of this product.