Connecting The Device - Bosch WUU28T41 Instructions For Use And Assembly

enSet up and connect

4.5 Connecting the device

water inlet hose
connect
WARNING
Electric shock hazard!
The device contains live parts.
Touching live parts is dangerous.
Do not immerse the electric
▶
Aquastop valve in water.
A notice:Make sure that you connect
the device to a water supply with a
safety device against drinking water
contamination through backflow
(according to DIN EN 1717). The
connection valves/water taps
provided for this purpose are
equipped with this safety device if the
house is properly installed.
Connect the water inlet hose to the
1.
tap (26.4 mm = 3/4").
Open the tap carefully and check
2.
whether the connection points are
tight.
Connection types water drainage
The information helps
Connect this device to
the Wa.
16
en you, the-
water flow
ATTENTION!
When pumping out, the water drain
hose is under pressure and can detach
from the installed connection point.
Secure the water drain hose
▶
against unintentional loosening.
A notice:Note the pump heights.
The maximum pumping height is 1
bathroom sink
plastic pipe
with rubber sleeve
or gully
The connection
place with one
hose clamp
(24-40 mm)
chern.
the water
running hose with
a manifold
→ page 28 fix and
secure.
the water
running hose with
a manifold
→ page 28 fix and
secure.