Bosch WUU28T41 Instructions For Use And Assembly page 43

Disturbance
Water doesn't run in.
Detergent will not
washed in.
Repeated
fling.
Change program duration
changes during the
washing process.
Water is not visible
in the drum
bar.
Drum jerks
program start.
In the chamber
there is residual
ser.
Cause and troubleshooting
Start/Reloadwas not pressed.
PressStart/Reload .
▶
Filter in the water inlet is clogged.
Clean the strainer in the water inlet.
▶
Water tap is closed.
Open the faucet.
▶
Water inlet hose is kinked or pinched.
Make sure the water inlet hose is not kinked or
▶
pinched.
Imbalance control system compensates for imbalance by
distributing the laundry several times.
No error - no action necessary.
▶
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Program flow is electronically optimized. This can lead
to a change in the program duration.
No error - no action necessary.
▶
Imbalance control system compensates for imbalance by
distributing the laundry several times.
No error - no action necessary.
▶
A notice:When loading, put as large and small items of
laundry as possible together in the drum. Items of
laundry of different sizes spread out better when
spinning.
Foam control system switches on a rinse cycle if the
foam builds up too much.
No error - no action necessary.
▶
Water is below the visible range.
No error - no action necessary.
▶
Do not add additional water to the device during
▶
operation.
The cause is an internal engine test.
No error - no action necessary.
▶
be
Insert in chamber is clogged.
→ "Cleaning the detergent drawer", page 33
▶
Troubleshootingen
43