Bosch WUU28T41 Instructions For Use And Assembly page 44

enTroubleshooting
Disturbance
vibration and movement
the appliance during
spinning.
drum turns,
Water doesn't run in.
strong foaming
dung.
high centrifugal
number is not
reached.
Spin program
does not start.
44
Cause and troubleshooting
Device is not aligned correctly.
→ "Align device", page 17
▶
Device feet are not fixed.
Fix the device feet.
▶
→ "Align device", page 17
Transport locks are not removed.
→ "Remove transport locks", page 14 .
▶
Load detection is active.
No error, no action necessary.
▶
A notice:The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate measure: Mix a tablespoon of fabric
▶
softener with 0.5 liters of water and pour the
mixture into the left chamber (not for outdoor,
sportswear and down textiles).
For the next wash cycle with the same load, reduce
▶
the amount of detergent.
Low spin speed is set.
Set a higher spin speed for the next wash cycle.
▶
Imbalance control system compensates for
imbalance by reducing spin speed.
Redistribute the laundry in the drum.
▶
A notice:Put large and small items of laundry together
in the drum. Items of laundry of different sizes spread
out better when spinning.
Start the programSling .
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and water drain hose.
▶
Drain pipe or water drain hose is kinked or pinched.
Make sure the drain pipe and water drain hose are
▶
not kinked or pinched.
Imbalance control system stopped spinning due to
uneven laundry distribution.
Redistribute the laundry in the drum.
▶