Cisco Aironet 1300 Series Installation Manual page 45

Configuring the Bridge for the First Time
This chapter describes how to configure basic settings on your bridge for the first time. The contents of
this chapter are similar to the instructions in the quick start guide that shipped with your bridge. You can
configure all the settings described in this chapter using the command-line interface (CLI), but it might
be simplest to browse to the bridge's web-browser interface to complete the initial configuration and then
use the CLI to enter additional settings for a more detailed configuration.
This chapter contains these sections:
Before You Start, page 5-2
•
Obtaining and Assigning an IP Address, page 5-3
•
• Connecting to the Bridge Locally, page 5-3
Assigning Basic Settings, page 5-4
•
• What To Do Next, page 5-9
Using the IP Setup Utility, page 5-9
•
• Assigning an IP Address Using the CLI, page 5-13
Using a Telnet Session to Access the CLI, page 5-13
•
OL-5048-01
C I S C O C O N F I D E N T I A L - F i r s t D r a f t
C H A P T E R
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
5
5-1