Shorten Segment; Divide Program - Panasonic SC-HT1000 Operating Instructions Manual

Shorten Segment

[RAM]
5
Press [ENTER] at the start point of the
section you want to erase.
Shorten
Segment
03 PLAY
Start
End
Next
3 0 : 00 . 01
SELECT
Start End
ENTER
RETURN
– : – – . – –
0 : 00 . 01
6
Press [ENTER] at the end point of the
section you want to erase.
Shorten
Segment
03
Start
End
Next
3 3 0 : 10 . 15
SELECT
Start End
ENTER
RETURN 0 : 00 . 01 0 : 10 . 15
To continue using Shorten Segment
1 Press [3, 4] to select "Next" and press [ENTER], then press [2]
to select "Erase" and press [ENTER].
2 Repeat steps 5 and 6.
3
Press [3, 4] to select "Exit" and
press [ENTER].
4
Press [2] to select "Erase" and press
[ENTER].
Segments are erased from the start to end point.
[Note]
≥You can use basic functions like fast forwarding and slow play
(➡page 18).
≥Play pauses if the end of the program is reached during this
procedure.
≥You cannot specify an end point before a start point.
≥You may not be able to specify points within 3 seconds of each
other.
≥You cannot specify points on still pictures in the program.
≥The disc's available recording time may not increase after erasing
short segments.
Exit
Exit

Divide Program

[RAM]
Select a point at which to divide the program into two.
5
Press [ENTER] at the point you want
to divide the program.
Divide
Program
03
Preview
Divide
3 0 : 00 . 01
SELECT
Divide
ENTER
RETURN 0 : 00 . 01
To confirm the division point
Press [3, 4] to select "Preview" and press [ENTER]. (Play
will begin from a point 10 seconds prior to and after the
division point.)
To change the division point
Restart play and press [3, 4] to select "Divide", then press
[ENTER] at the point you want to change.
6
Press [3, 4] to select "Exit" and
press [ENTER].
7
Press [2] to select "Divide" and press
[ENTER].
The program is divided.
[Note]
≥The divided programs retain the title and CPRM property
(➡page 51) of the original program.
≥A very small portion of the recording preceding the division point
may be lost.
≥It is not possible to carry out Divide Program in the following cases:
–when the program is extremely short.
–when the total number of programs is more than 99.
Exit
RQT7061
31