Use; Switching On; Setting The Room Temperature; Setting The Power - Ravelli BLOCK 7 STONE Installation, Operation And Maintenance Manual

ENGLISH

15 USE

15.1 SWITCHING ON

Before each switching on, make sure that the
ash drawer is not full and that it is in place.
Hold down the icon
the appliance.
The words "Powering on..." will appear, and
"Current state" will switch from "Off" to:
• Start - control 1
• Start - control 2
• Start
• Start - cleaning
• Start - loading
• Pause
• Start - phase 1
• Start - phase 2
• Start - stabilise
• Work
170
for two seconds to start
Fig. 15.1
Fig. 15.2
Fig. 15.3
Automatic switching on: the appliance is
equipped with an automatic device that switches
on the pellet without using other igniters.
Avoid switching the appliance on manually if the
automatic switching on system is compromised.
The first time the appliance is switched on,
unpleasant odours or smoke can be generated
due to the evaporation or drying of some
of the manufacturing materials. This will
gradually disappear. During the first few uses,
we recommend ventilating the rooms well.
15.1.1 "Sealed" appliances
Every time the firebox door and/or pellet hopper
are opened, avoid leaving them open for more
than a minute to prevent the system from
notifying the status of open door and/or open
hopper.
15.2 SETTING THE ROOM
TEMPERATURE
By changing
temperature that you want to achieve in the
room, read directly by a probe installed on the
appliance.
To change the temperature value, press
.
The settable values range from 5°C to 40°C.

15.3 SETTING THE POWER

The power defines the amount of heat produced
by the appliance and therefore indirectly also
affects consumption.
To edit the power value press icons
settable values go from 1% (minimum) to 100%
(maximum).
this value you define
or
the
or
Fig. 15.4
: the