KMC Controls CTE-1005 Installation Manual

Required Tools
• digital voltmeter
• small phillips screwdriver
• small flatblade screwdriver
• keyhole saw
Mounting
Standard:
•
The base unit's mounting slots are designed to align with the
holes in a standard 2" x 4" (51x102) handy conduit box.
•
Use a 2" (51) deep box if using conduit.
•
Normal screw and anchor systems may be used on solid
walls.
Hollow wall:
1. Cut a 3-3/4" x 1-3/4" rectangular opening in the wall.
(Check if unit is horizontal or vertical before cutting)
2. Make all necessary connections
3. Insert Toggle Bolt Assembly (HMO-5001, ordered separately)
through the wall and tighten.
Care should be taken not to bend or flex the base of the
thermostat.
Wiring
Typically, T1 and T3 are used for cooling and T2
and T4 are used for heating. Refer to the wiring
diagram.
Dual Temperature Room Thermostat
Installation Guide
CTE –1005, 1008, 1105, 1108