Advertisement
"Id" is used to enable the same function: press ENTER button followed by UP or DOWN
button to choose "ON" or "OFF" to enable or disable the ID address function.
"RGbW" is used to activate the color correction setting: press ENTER button followed by
UP or DOWN button to choose "ON" or "OFF" to enable or disable the color correction
setting.
"dIM" is dimming curve speed setting (refer to "dimming speed table" at page 26).
It uses the 16-bit operating control board to gradually smooth, with different curves, the
dimming speed of the LEDs and let you set non-linear curves to increase the smoothness
of the dimming when turning off the light or rapidly changing colors.
2.3.10 WHITE BALANCE SETTING (CAL1)
CAL1
Different white balance presets can be set and modified with custom values to obtain
different color temperature corrections.
To set the white balance presets press MENU until "CAL1" is displayed.
Press ENTER button and use UP or DOWN buttons to choose one of the programs. Press
ENTER button repeatedly to scroll through Red, Green, Blue and White values.
Use UP or DOWN buttons to modify current value.
After selecting the white balance setting, you don't have to exit the submenu. In this way
the fixture will maintain this values and will continue displaying the last edited value: even
if turned off this will persist when powered on again after next reboot.
To exit the white balance setting mode, simply press the MENU button once. This will take you
back to the main menu ("CAL.1" is displayed), where you can scroll through the various operating
modes and functions.
Please note: when DMX channel mode is set on "STAG", channel 6 can be used to select
one of these programs (WT.01-WT.11).
WT.01
WT.11
19
(0-255)
R.000
(0-255)
G.000
(0-255)
b.000
(0-255)
W.000
Advertisement
