Advertisement
2.3.9 NATIVE SETTING (SET)
SET
To change the setting of the unit entering the native setting mode press MENU until "SET"
.
appears
"UPLd" is intended to transfer programming data between units: just press ENTER; then
proceed entering password confirmation by pressing UP, DOWN, UP, DOWN followed by
ENTER.
If the transfer is successfully started the Master unit and all the slave units will first turns
yellow, indicating that data transfer is in progress (the progress of the upload is shown on
the 4-digit display). Once the transmission is complete, the lights of the master unit will
turn green. Slave units, similarly, emit yellow light when receiving and turn green after the
transmission in complete.
"REST" is used to restore the default factory settings: press ENTER button followed by the
sequence: UP, DOWN, UP, DOWN, then press ENTER again to confirm (custom programs
are not overwritten).
UPLd.
REST.
Id.
RGbW.
dIM.
18
OFF.
ON.
OFF.
ON.
OFF.
dIM1.
dIM2.
dIM3.
dIM4.
Advertisement
