Table of Contents
Advertisement
„the unique IP address (as set by LAN-Address, see above)"
emulator"
e.g.
141.187.6.53
141.187.6.53
When saving again the file Lmhosts get sure that your editor (e.g. notepad) will
not add any extension, e.g. .txt, to your file. To be sure, use quotation marks for
the filename:
e.g. File save as: "lmhosts" (or lmhosts.sam)
7.4 Checking the network-connection
Disconnect serial RS232 (or USB) cable from Emulator and try to find the emulator:
• Open DOS-Window (or open RUN ("Ausführen" in german Windows
Start-Menu)
• The command
that means the network is set up right.
The emulator with LAN-adapter is successfully integrated in the network environment
and can be used by the Softune Workbench.
7.5 Troubleshooting
If the command
ping my_emulator
emulator by its IP-address: Type command
.
141.187.6.53
If this will work, then check settings (nickname and IP-address) within Lmhosts and
Hosts.
If neither nickname (my_emulator) nor IP-address works, check settings done by
the program LAN-address and check the file Services.
Also check your physical network interconnection cables. Please keep in mind that
the emulator only works with 10Mbit/s. This means in case that for a 100Mbit/s
network a 100Mbits/10Mbit - HUB is needed. When using a HUB for 10Base-T then
a standard (1:1) network cable has to be used. If the emulator is connected directly
to the PC a „crossed network cable" is necessary.
MCU-AN-300217-E-V10
MB2198 – Getting Started
Chapter 7 Installing LAN
fjicescv
Emulator
should acknowledge with some time-values,
ping Emulator
will reply with a timeout-message, try to find the
- 30 -
, e.g.
ping IP-address
© Fujitsu Microelectronics Europe GmbH
„nickname of
TM
) in the
ping
Advertisement
Table of Contents
