Establish Can Bus Wiring - Brivo ACS6100 Installation Manual

Installation Procedures

Establish CAN Bus Wiring

NOTE: The B-ACS6100R-E/S and B-ACS6100L-E/S chassis include a pre-assembled CAN Bus connection cable. This
cable should be used for connecting panels within the same chassis. The B-ACS6100R-E/S chassis include a 4-board
connection cable, and the B-ACS6100L-E/S includes an 8-board connection cable. The installer must still manually
wire connections between each individual chassis.
NOTE: The B-AC6100R-E/S enclosures CAN Bus cable has four connectors and the B-ACS6100L-E/S CAN Bus cable
has eight connectors. In a B-ACS6100R-E/S enclosure, you have the option to connect a mainboard to up to two
door and/or IO boards or to connect up to four door and/or IO boards together using the provided pre-assembled
CAN Bus cable. In a B-ACS6100L-E/S enclosure, you have the option to connect a mainboard to up to six door and/
or IO boards or to connect up to eight door and/or IO boards together using the provided pre-assembled CAN
Bus cable. Upon completion, there may be an extra connector if you are installing a MAIN CONTROL BOARD into a
chassis (standard or large). The installer may cut this connector off should they deem it necessary.
1. If there are expansion boards in the control chassis, connect them to the MAIN CONTROL BOARD.
2. If there are expansion chassis, in each chassis connect the expansion boards as shown below.
© 2022 Brivo Systems LLC. All rights reserved.
Figure 13 - Connect Expansion Board to MAIN CONTROL BOARD
21
Brivo ACS6100 Installation Manual
PUB-Brivo ACS6100 Installation Manual