Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FlySky FS-MG7
Summary of Contents for FlySky FS-MG7
- Page 1 FS-MG7 USER MANUAL USER MANUAL Automatic Frequency Hopping Digital System Website...
- Page 2 Read the manual carefully to ensure your personal safety as well as the safety of your equipment. If you encounter any problems during using, please refer to this manual first. If the problem is still not resolved, please contact the local dealer directly or contact the customer service staff via the website below: http://www.flysky-cn.com...
-
Page 3: Table Of Contents
Contents 1.Safety ..................1 1.1 Safety Symbols ........................1 1.2 Safety Guide ..........................1 2.Introduction ................2 2.1 Transmitter Overview ......................2 2.2 Receiver Overview ���������������������������������������������������������������������������������������������������������������3 Status 2.2.1 The LED of the Receiver ......................3 2.2.2 Interface ..............................3 2.2.3 Antenna ..............................3 3.Getting Started ................ - Page 4 5.16 Factory Reset ........................13 6. FS-R7D Function Instructions ........... 14 6.1 Attentions ..........................14 6.2 Binding Instruction ........................ 14 6.3 Car Light Control ........................14 6.4 Firmware Update ........................15 6.5 Failsafe ............................ 15 7. Customized Definition ............. 16 7.1 Steering Wheel Angle Adjustment Instruction ..............
-
Page 5: Safety
1.Safety 1.1 Safety Symbols Pay close attention to the following symbols and their meanings� Failure to follow these warnings could cause damage, injury or death� Danger • Not following these instructions may lead to serious injuries or death. Warning • Not following these instructions may lead to major injuries. -
Page 6: Introduction
Automatic Frequency Hopping Digital System 2.Introduction The FS-MG7 is a 7-channel transmitter which is compatible with the 2.4GHz ANT Automatic Frequency Hopping Digital System, featuring compact design, comfortable to the hand, ergonomic. In addition, the ESC parameters can be set at the transmitter side. The transmitter also has a beginner mode for beginners. -
Page 7: Receiver Overview
2.2 Receiver Overview Take FS-R7D receiver as an expample. [10] [14] [15] [16] [17] [18] [19] [20] [21] [11] [12] [13] CH1（PPM） [12] Right turn signal light interface [13] Left turn signal light interface [14] [15] Antenna [16] Bind button [17] + (Power anode for light interface) [18]... -
Page 8: Getting Started
FS-MG7 Automatic Frequency Hopping Digital System 3.Getting Started Prior to operations, please install the battery and connect devices according to the sequence and guide as described in this chapter. 3.1 Transmitter Anttena The transmitter has a built-in antenna. When the transmitter starts to work, the antenna automatically operate, without additional operations. -
Page 9: Installing Transmitter Battery
3.3 Installing Transmitter Battery Danger • Only use specified battery (X4 AAA batteries). Danger • Do not open, disassemble, or attempt to repair the battery. Danger • Do not crush/puncture the battery, or short the external contacts. Danger • Do not expose to excessive heat or liquids. Danger •... -
Page 10: Operation Guide
FS-MG7 Automatic Frequency Hopping Digital System 4. Operation Guide After setting up, follow the instructions below to use the product. 4.1 Power-on Follow the steps below to turn on the transmitter: Check to make sure that the batteries are fully charged and installed correctly. -
Page 11: Binding
After the receiver LED becomes slow flashing, then restart the transmitter. At this time, the receiver LED is solid on, indicating the binding is successful. The binding steps may vary according to the receiver model. Visit the Flysky official website to check the manual of the receiver or other relevant information. -
Page 12: Stick Calibration
FS-MG7 Automatic Frequency Hopping Digital System 4.5 Stick Calibration Calibrate the maximum and minimum travel of the steering wheel and throttle trigger. The factory calibration is completed. If you need to recalibrate the transmitter, follow the steps below: Turn the transmitter steering wheel clockwise to the maximum travel, push the throttle trigger forward to the maximum travel, and power it on. -
Page 13: System Functions
5.System Functions This section focuses on the functions and how to use them. 5.1 Channel Description The transmitter outputs a total of 7 channels, the function assignment and settings are as follows. Channel Assigned Control Function(Normal mode) Function (2-in-1 mode) Steering, to control the left/right steering. -
Page 14: Channel Reverse
FS-MG7 Automatic Frequency Hopping Digital System 5.3 Channel Reverse To reverse the output direction of the channel. For 2-in-1 mode, it can adjust the direction of CH1 and CH2 only. For non-2-in-1 mode, it can adjust the direction of CH1-CH7. -
Page 15: Switching Model
5.6 Switching Model The transmitter supports five sets of models. • Press and hold the CH6 and CH7 buttons of the transmitter and power it on. That is, it enters the mode of switching model. When the switching is successful, the buzzer will sound at different times in prompt tones. See the following table. -
Page 16: Failsafe
FS-MG7 Automatic Frequency Hopping Digital System is successful, The D1 LED works in two-flash-one-off mode in green for 3S cyclically and the buzzer will sound once shortly with Tone In case of power-on, you can judge the mode of the transmitter according to the D1 LED status and buzzer sound: If the D1 LED works in two-flash-one-off mode in green for 3S cyclically and the buzzer sounds once shortly with Tone 2, it is the beginner mode;... -
Page 17: Sleep Mode
5.12 Sleep Mode When a 2-in-1 receiver has connected and the transmitter has been in idle alarm state over 2 minutes, it will enter the sleep mode. • In this mode, the D1 LED will be in orange gradual light state, the buzzer and RF will turn off. The transmitter is not responsive in case of operations of any control. -
Page 18: Fs-R7D Function Instructions
FS-MG7 Automatic Frequency Hopping Digital System 6. FS-R7D Function Instructions This section instruct how to use FS-R7D receiver and the attentions. FS-R7D is a light group 7-channel receiver in compliance with the ANT protocol with a single external antenna, two- way transfer-back function. -
Page 19: Firmware Update
6.4 Firmware Update The firmware of this receiver is updated through the FlyskyAssistant (Only version 3.0 or later is supported. The firmware of FlyskyAssistant is available on the Flysky official website). This receiver can be updated via the following two ways:... -
Page 20: Customized Definition
FS-MG7 Automatic Frequency Hopping Digital System 7. Customized Definition 7.1 Steering Wheel Angle Adjustment Instruction Fllow the steps below to adjust the angle of the steering wheel. Hold the side of the steering wheel, and at the same time First insert a hexagonal... - Page 21 The slot of steering wheel Insert the screw into the screw hole used to secure the steering Align screws screwed in the wheel, then align the hexagonal brake pad with the screw holes screwdriver with the hexagonal on the steering wheel.. At the hole in the head of the screw, same time, press the brake hold the side of the steering...
-
Page 22: Specifications
FS-MG7 Automatic Frequency Hopping Digital System 8. Specifications This section contains FS-MG7 transmitter and FS-R7D receiver specifications. 8.1 Transmitter Specifications Product Model FS-MG7 Compatible Receivers FS-R7D, receivers with ANT protocal Compatible Models Cars or boats Number of Channels 2.4GHz ISM <... -
Page 23: Receiver Specifications
8.2 Receiver Specifications Product Model FS-R7D Compatible Transmitters FS-MG7 Compatible Models Cars PWM Channels Number of Lights 2.4GHz ISM 2.4GHz Protocol Input Power 3.5 ～ 9V /DC Working Current < 90mA/5V Maximum Power < 20dBm (e.i.r.p.) （EU） Distance >300m (Ground distance without interference) -
Page 24: Package Contents
FS-MG7 Automatic Frequency Hopping Digital System 9. Package Contents This section contains FS-MG7 transmitter package contents. Number Name Quantity FS-MG7 Transmitter FS-R7D Receiver Quick Start Guide Screws ( Using for the steering wheel angle adjustment) Website... -
Page 25: Certifications
10. Certifications 10.1 DoC Declaration Hereby, we declare that the Radio Equipment [FS-MG7] is in compliance with RED 2014/53/EU. The full text of the EU DoC is available at the following internet address: www.flyskytech.com/info_detail/10.html 10.2 CE Warning The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other transmitter. -
Page 26: Environmentally Friendly Disposal
FS-MG7 Automatic Frequency Hopping Digital System 10.4 Environmentally friendly disposal Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. - Page 27 Website CE， FCC ID： 2A2UNMG700 www.flysky-cn.com Copyright ©2022 Flysky Technology co., Ltd. Release date: 2022-11-21 Manufacturer: ShenZhen FLYSKY Technology Co., Ltd. Address: 16F, Huafeng Building, No. 6006 Shennan Road, Futian District, Shenzhen, Guangdong, China...