Table of Contents
Advertisement
requirements and limits are designed to provide reasonable protection against harmful
interference when the product is operated in its intended operational electromagnetic
environment.
This product is intended for use in residential, commercial, and industrial locations. However,
harmful interference may occur in some installations or when the product is connected to a
peripheral device or a test object. To minimize interference with radio and television reception
and prevent unacceptable performance degradation, install and use this product in strict
accordance with the instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved by National
Instruments could void your authority to operate it under your local regulatory rules.
Caution
shielded cables and accessories. Do not use unshielded cables or accessories unless
they are installed in a shielded enclosure with properly designed and shielded input/
output ports and connected to the product using a shielded cable. If unshielded
cables or accessories are not properly installed and shielded, the EMC specifications
for the product are no longer guaranteed.
Caution
beads (777297-01) per connected I/O cable in accordance with the product
installation instructions.
Caution
connected to the input port(s) must be no longer than 3 m (10 ft).
Unpacking the Kit
Caution
ground yourself using a grounding strap or by holding a grounded object, such as
your computer chassis.
1.
Touch the antistatic package to a metal part of the computer chassis.
2.
Remove the device from the package and inspect the device for loose components or any
other sign of damage.
Caution
Note
3.
Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.
Verifying the Kit Contents
Verify that the following components are in your kit.
2 | ni.com | NI PXIe-7822R Getting Started Guide
To ensure the specified EMC performance, operate this product only with
To ensure the specified EMC performance, install two (2) snap-on, ferrite
To ensure the specified EMC performance, the length of any cable
To prevent electrostatic discharge (ESD) from damaging the device,
Never touch the exposed pins of connectors.
Do not install a device if it appears damaged in any way.
Advertisement
Table of Contents
