Shifting - Yamaha XSR700M 2021 Owner's Manual

Operation and important riding points
NOTICE
If a warning or indicator light does
not work as described above, have a
Yamaha dealer check the vehicle.
3. Shift the transmission into neutral.
4. Push the start switch " " to crank
the engine with the starter.
Release the start switch when the
engine starts, or after 5 seconds.
Wait 10 seconds before pressing
the switch again to allow battery
6
voltage to restore.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
ECA24110

Shifting

6
5
4
1 3
2
N
1
ZAUM1346
1. Gear positions
2. Shift pedal
Shifting gears lets you control the
ECA11043
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position ( ), press the shift pedal
down repeatedly until it reaches the
end of its travel, and then slightly raise
it.
EAU16674
NOTICE
 Even with the transmission in
2
 Always use the clutch while
To start out and accelerate
1. Pull the clutch lever to disengage
2. Shift the transmission into first
3. Open the throttle gradually, and at
6-2
the neutral position, do not
coast for long periods of time
with the engine off, and do not
tow the motorcycle for long dis-
tances. The transmission is
properly lubricated only when
the engine is running. Inade-
quate lubrication may damage
the transmission.
changing gears to avoid dam-
aging the engine, transmission,
and drive train, which are not
designed to withstand
shock of forced shifting.
the clutch.
gear. The neutral indicator light
should go out.
the same time, release the clutch
lever slowly.
ECA10261
the
EAU16682