Switching The Projector On/Off; Power Cord - Panasonic PT-F300NTU Operating Instructions Manual

Switching the projector on/off

Power cord

Connecting
1. Make sure the shape of the power plug and the
AC IN terminal on the back of the projector match,
then push the plug all the way in.
2. Align the side of the power cord secure lock with
the side guide rail of the AC IN terminal of the
projector and slide it in.
3. Place the latch to the latch catcher and press until
it clicks.
Latch
4. Connect the power cord to a wall outlet.
NOTE:
• Do not use other than the provided power cord.
• Ensure all the input devices are connected and turned off before connecting the power cord.
• Do not force the connector as this may damage the projector and/or the power cord.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.
• If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may take
a while to start the projection.
Direct power on function
You can start the projection with only supplying the
electric power. See "INITIAL START UP" on
page 41.
1. Unplug the power cord from the wall outlet.
2. Depress the latch and slide the cover off.
3. Slide the power cord secure lock up along the side
Rail guide
4. Hold the plug and unplug the power cord from the
Disconnecting
Latch
guide rail and remove.
AC IN terminal on the back of the projector.
Power indicator lights in orange if the internal cooling
fan is still operating by internal power supply.
Direct power off function
You can switch off the electric power supply any
time by unplugging the power plug from the wall
outlet or by switching off the main power. The
internal lamp cooling fan keeps operating by the
internal power supply, and stops automatically
when cooled enough.
Rail guide
E
NGLISH - 21