Remote Control Operation; Operating Range; Setting Up The Image Position Automatically - Panasonic PT-F300NTU Operating Instructions Manual

Remote control operation

Operating range

(Shown as PT-F300NTU)

Setting up the image position automatically

You can adjust the setting of SHIFT, DOT
CLOCK and CLOCK PHASE in the POSITION
menu automatically for the projected
COMPUTER signal image.
With DVI signal, adjust SHIFT setting only.
NOTE:
• If the dot clock frequency is 150 MHz or higher, AUTO
SETUP is not effective.
• If the projected image is dark or blurred around the
edge, AUTO SETUP may stop the processing before
complete. Project a much clearer or lighter image and
press the AUTO SETUP button again.
• When there is no signal input and SIGNAL SEARCH in
DISPLAY OPTION menu is ON, the auto signal
detecting system will start.
You can operate the projector with the remote control
within the remote range 15 m (49'2"), approximately
± 30° vertically and horizontally.
Facing to the projector
Ensure the remote control emitter is facing to the
remote control signal receptor on front/back of the
projector and press the required buttons to
operate.
Facing to the screen
Ensure the remote control emitter is facing to the
screen and press the required buttons to operate
the projector. The signal will be reflected off the
screen. The operating range may differ due to the
screen material. This function may not be effective
with a translucent screen.
NOTE:
• Do not let strong light shine onto the signal receptor.
The remote control may malfunction under strong light
such as fluorescent.
• If there are any obstacles between the remote control
and the remote control signal receptor, the remote
control may not operate correctly.
Screen Projected image
E
NGLISH - 25