Table of Contents
Advertisement
Switching the projector on/off
Mains lead
Connecting
1. Make sure the shape of the mains plug and the
AC IN terminal on the back of the projector match,
then push the plug all the way in.
2. Align the side of the power cord secure lock with
the side guide rail of the AC IN terminal of the
projector and slide it in.
3. Place the latch to the latch catcher and press until
it clicks.
Latch
4. Connect the mains lead to a mains socket.
NOTE:
• Do not use other than a provided mains lead.
• Ensure all the input devices are connected and turned off before connecting the mains lead.
• Do not force the connector as this may damage the projector and/or the mains lead.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.
• If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may take
a while to start the projection.
Direct power on function
You can start the projection with only supplying the
electric power.
See "DIRECT POWER ON" on
page 39.
1. Unplug the mains lead from the mains socket.
2. Depress the latch and slide the cover off.
3. Slide the power cord secure lock up along the side
Rail guide
4. Hold the plug and unplug the mains lead from the
Disconnecting
Latch
guide rail and remove.
AC IN terminal on the back of the projector.
POWER indicator lights in orange if the internal
cooling fan is still operating by internal power supply.
Direct power off function
You can switch off the electric power supply any
time by unplugging the mains plug from the mains
socket or by switching off the main power. The
internal lamp cooling fan keeps operating by the
internal power supply, and stops automatically
when cooled enough.
Rail guide
E
NGLISH - 23
Advertisement
Table of Contents
