Table of Contents
Advertisement
Read this first
Minimum required setting screen
When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
LANGUAGE
Select the required language setting.
LANGUAGE
PLEASE SELECT LANGUAGE
SELECT
Press F G I H buttons of the Remote control or
Control panel on the projector to highlight the
required language, and press ENTER to proceed to
the next setting.
OPTION
Select the current projection method and fan speed
setting. If you need return to the previous setting,
press the RETURTN button.
OPTION
INSTALLATION
ALTITUDE
SWITCH TO HIGH ALTITUDE MODE "HIGH" IF OVER 1400m(4593Ft).
SELECT
Press the ENTER button to start the projection.
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is
initialised. See "INITIALIZE ALL" on page 40.
You can change the settings from the MAIN MENU. See "Menu Navigation" on page 31.
ENTER
FRONT/DESK
LOW
RETURN
ENTER
INSTALLATION
Press I H buttons of the Remote control or
Control panel on the projector to select the
required installation method. Press G to proceed to
the ALTITUDE setting.
Setting on a desk/floor and
FRONT/DESK
projecting from front
Mounting in the ceiling and
FRONT/CEILING
projecting from front
Setting on a desk/floor and
REAR/DESK
projecting from rear
Mounting in the ceiling and
REAR/CEILING
projecting from rear
ALTITUDE
If you use the projector at high elevation, the
ALTITUDE setting need to be HIGH to set the fan
speed high. Press I H to select the required
option. If you need to return to the INSTALLATION,
press F.
LOW
The fan speed is low.
HIGH
The fan speed is high.
NOTE:
• At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the
setting must be HIGH.
• The loudness of fan noise depends on the ALTITUDE
setting.
E
NGLISH - 13
Advertisement
Table of Contents
