Installation; Sleep; Altitude; Lamp Power - Panasonic PT-AE1000U Operating Instructions Manual

INSTALLATION

When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See "Projection method"
on page 15.
Setting on a desk/floor and

FRONT/DESK

projecting from front
Mounting in the ceiling and

FRONT/CEILING

projecting from front
Setting on a desk/floor and

REAR/DESK

projecting from rear
Mounting in the ceiling and

REAR/CEILING

projecting from rear

SLEEP

You can select the required duration of time and set the
off timer to turn off the POWER of the projector
automatically. 3 minutes before turn-off, the countdown
of minutes will be displayed in the lower right corner.
Press I H to cycle through the options. See "Switching
off the projector automatically" on page 25.

ALTITUDE

If you use the projector at high elevations, set the fan
speed to HIGH. Press I H to select HIGH or LOW.
NOTE:
At 1 400 m (4593 ft) above sea level, the setting
must be HIGH.

LAMP POWER

You can adjust the power of the lamp to save on
electricity, prolong the lamp life and reduce the noise.
Options
When higher luminance is
NORMAL
required such as movies
When lower luminance is
ECO - MODE
sufficient such as in a small room
NOTE:
When no input signal is detected, the function is
disabled.
Function

LAMP RUNTIME

You can check how long the lamp has been used.
NOTE:
LAMP RUNTIME is a relevant matter for lamp
replacement timing. See "Care and Replacement"
on page 41.

FUNCTION BUTTON

You can assign frequently used functions to each
function button and access the functions instantly.

FUNCTION BUTTON

FUNCTION BUTTON1
FUNCTION BUTTON2
FUNCTION BUTTON3
1. Press F G to select the required button to assign.
2. Press ENTER.
3. Press I H to select the required function to
assign.
4. Press RETURN or MENU to return to the previous
menu, or press repeatedly to return to the
projection.
DISABLED
HDMI2 IN
HDMI1 IN
PC IN
COMPONENT2 IN
SHUTTER function
You can turn off the lamp and stop the projection
temporary for electrical power save. Press any
button except the LIGHT, DEVICE or Learning
Remote control buttons to return to the
projection.
NOTE:
See "Selecting the input signal" on page 21,
"AUTO SETUP" on page 36.
The function buttons are also used as Learning
Remote control buttons. Press the DEVICE button
to switch the control mode. See "Remote Control
Operating Guide" provided with the projector.
OPTION Menu
OFF
OFF
OFF
SHUTTER
AUTO SETUP
VIDEO IN
S-VIDEO IN
COMPONENT1 IN
E
NGLISH
- 39