Projecting An Image; Selecting The Input Signal; Positioning The Image - Panasonic PT-AE1000U Operating Instructions Manual

Projecting an image

Selecting the input signal

1. Switch on the connected devices.
Press the play button of the required device.
NOTE:
AUTO SEARCH is ON as default and the signal from the connected devices is detected automatically. See
"AUTO SEARCH" on page 38.

Positioning the image

1. Press ASPECT to select the required aspect
mode. See "Switching the aspect ratio" on
page 23.
2. Adjust the projected image with the Lens
shift dials. See "Lens shift and positioning"
on page 16.
3. Adjust the angle of the projector.
Screw down the Front leg adjuster and adjust
the angle vertically.
NOTE:
Do not touch the Air exhaust port as this may
cause burns or injury.
If keystone distortion occurs, see "KEYSTONE"
on page 36.
2. INPUT
Press the button to select the required
input method if needed. See "Switching the input
signal" on page 23.
The image will be projected on the screen.
4. Adjust the focus and the projected image
size.
Press +/- of the FOCUS and ZOOM buttons to
adjust.
Press the LENS button to adjust the focus and
zoom by Remote control. see "LENS
CONTROL Menu" on page 37
E - 21
NGLISH