Projection Method; Front Leg Adjuster And Throwing Angle - Panasonic PT-AE1000U Operating Instructions Manual

Projection method

You can use the projector with any of the following 4 projection methods. To set the desired method in the projector,
see "INSTALLATION" on page 39.
Setting on a desk/floor and
projecting from front
INSTALLATION: FRONT/DESK
Mounting in the ceiling and
projecting from front
INSTALLATION: FRONT/CEILING
NOTE:
A translucent screen is required for REAR projection.
When mounting the projector in the ceiling, the optional ceiling mount bracket (ET-PKX100, ET-PKE1000S)
is required.

Front leg adjuster and throwing angle

You can adjust the throwing angle by screwing the front legs up/down.
This adjust the angle of the projector. See "Positioning the image" on page 21.
NOTE:
Heated air comes out of the Air exhaust port. Do not touch the Air exhaust port directly.
If keystone distortion occurs, see "KEYSTONE" on page 36.
Setting on a desk/floor and
projecting from rear
INSTALLATION: REAR/DESK
Mounting in the ceiling and
projecting from rear
INSTALLATION: REAR/CEILING
Setting up
E - 15
NGLISH