Adjusting The Waveform Of The Input Signal - Panasonic PT-AE1000U Operating Instructions Manual

Remote control operation

Adjusting the waveform of the input signal

You can monitor if the brightness and
contrast level of the input signal is in the
recommended range by displaying it in the
waveform monitor. See "WAVEFORM
MONITOR" on page 32.
1. Project a commercial adjusting signal.
2. Press the WAVEFORM button to display the
waveform monitor.
OFF
FULL SCAN
SINGLE LINE
SCAN
3. Press ENTER button to select the required
adjusting mode.
FULL SCAN(Y)
FULL SCAN(R)
FULL SCAN(G)
FULL SCAN(B)
4. Press F G I H to adjust the displaying
position of the waveform monitor.
5. Adjust the waveform in each menu.
NOTE:
When you adjust the SINGLE LINE SCAN, the
position of the waveform is depends on the
position of the selected line.
When the WAVEFORM displayed, the COLOR
MANAGEMENT is disabled.
100%
50%
0%
ENTER
24 - E
NGLISH
Deactivate the waveform monitor.
Monitoring the waveform of
brightness and contrast of the
whole image.
Monitoring the waveform of
detailed brightness and contrast in
each horizontal line of the image.
Press F G to select the required
line.
SINGLE LINE SCAN(B)
SINGLE LINE SCAN(G)
SINGLE LINE SCAN(R)
SINGLE LINE SCAN(Y)
Adjusting the waveform
Make sure to adjust to the 0% line first. Any signal level
below the recommended range will be forced to 0%.
Adjusting in PICTURE menu
Press PIC. ADJUST button to display the
PICTURE menu and adjust BRIGHTNESS
(-32 to +32) and CONTRAST (-64 to +64) with
I H.
BRIGHTNESS
CONTRAST
Adjusting in ADVANCED menu
Press PIC. ADJUST twice to display the
ADVANCED menu and adjust BRIGHTNESS
(-16 to +16) and CONTRAST (-32 to +32) in red,
green and blue with I H.
In red
BRIGHTNESS R
CONTRAST R
In green
BRIGHTNESS G
CONTRAST G
In blue
BRIGHTNESS B
CONTRAST B
NOTE:
When the Main menu (except WAVEFORM and
individually displayed menu item) is displayed, the
waveform monitor will be halt.
When the waveform monitor is displayed, the
Main menu will be displayed in order not to
interfere the waveform monitor.
Adjust to 100%
100%
50%
Optimal
dynamic range
0%
Monitor position
Adjust to 0%
Adjust the bottom line of the
waveform to 0 % (0/7.5 IRE).
Adjust the top line of the waveform
to 100 % (100 IRE).
Adjust the bottom line of the
waveform to 0 % (0/7.5 IRE).
Adjust the top line of the waveform
to 100 % (100 IRE).
Adjust the bottom line of the
waveform to 0 % (0/7.5 IRE).
Adjust the top line of the waveform
to 100 % (100 IRE).
Adjust the bottom line of the
waveform to 0 % (0/7.5 IRE).
Adjust the top line of the waveform
to 100 % (100 IRE).
PC/HDMI (Expand)
Adjust to 100%
100%
50%
Optimal
dynamic range
0%
Monitor position
Adjust to 0%