Remote Control Operation; Operating Range; Turning On The Button Backlight; Resetting To The Factory Default Settings - Panasonic PT-AE1000U Operating Instructions Manual

Remote control operation

Operating range

Turning on the button backlight

In a dark room, you can turn on the button
backlight to operate the Remote control.
Press the button on the upper right corner of
the unit to turn on the backlight and enter
the light-on mode.

Resetting to the factory default settings

You can reset most of the customized
settings to the factory defaults by pressing
DEFAULT button of the Remote control.
Display the required sub menu or the menu
items and press the button again. See
"Main menu and Sub-menu" on page 29.

Capturing an image

When projecting an image, press FREEZE
to capture the projected image and display
it on the screen as a still picture. Press
again to escape.
22 - E
NGLISH
You can operate the projector with the Remote control
within the remote range 7 m.
Facing to the projector
Ensure the Remote control emitter is facing to
the Remote control signal receptor on front of
the projector and press the required buttons to
operate.
Facing to the screen
Ensure the Remote control emitter is facing to
the screen and press the required buttons to
operate the projector. The signal will be reflected
off the screen. The operating range may differ due
to the screen material.
NOTE:
The Remote control may malfunction under
strong light such as a fluorescent. Do not let
strong light shine onto the signal receptor.
If there are any obstacles between the remote
control unit and the receptor, the Remote control
may not operate correctly.
After 30 seconds without any operation, the backlight
will go out. Press any but the LIGHT button to turn on
again. To escape from the light-on mode, press the
LIGHT button.
NOTE:
Some menu items are not available to reset by
pressing the DEFAULT button. Adjust each menu
items manually.
NOTE:
Escaping from the freeze mode is available by
pressing any button except the LIGHT button.