How To Operate Your Ceiling Fan - Fanimation AMPED FP7634 Series Manual

How to Assemble Your Light Kit (Continued)
3. Assemble the light kit assembly to the adaptor plate
of the motor assembly using the previously removed
screws and securely tighten all three screws.
(Figure 3)
1. IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3.
To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting
process. (If not used for long periods of time, remove
battery to prevent damage to transmitter). Store the
remote away from excessive heat or humidly.
(Figure 3)

How to Operate Your Ceiling Fan

For illustrative purposes only-not
intended to cover all types of controls
12V 23A
Battery (1 pcs)
14
Screws (3)
Light Kit Assembly
Figure 3
Figure 1
Main Fuse Box
Figure 2
Figure 3