Related Manuals for Maktec 6260D
Summary of Contents for Maktec 6260D
- Page 1 INSTRUCTION MANUAL Cordless Driver Drill 6260D 6270D 6280D 6390D 005216 IMPORTANT: Read Before Using.
-
Page 2: Specifications
) : 70 dB(A) or less Designation of Machine: Uncertainty (K) : 3 dB(A) Cordless Driver Drill The noise level under working may exceed 80 dB(A) Model No./ Type: 6260D,6270D,6280D,6390D Wear ear protection are of series production and ENG202-3 Conforms to the following European Directives:... -
Page 3: General Power Tool Safety Warnings
EN60745 Do not abuse the cord. Never use the cord for The technical documentation is kept by our authorised carrying, pulling or unplugging the power tool. representative in Europe who is: Keep cord away from heat, oil, sharp edges or Makita International Europe Ltd, moving parts. - Page 4 18. Do not use the power tool if the switch does 29. Follow instruction lubricating not turn it on and off. Any power tool that cannot changing accessories. be controlled with the switch is dangerous and 30. Keep handles dry, clean and free from oil and must be repaired.
-
Page 5: Functional Description
result in a risk of overheating, possible burns FUNCTIONAL DESCRIPTION and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical CAUTION: attention right away. It may result in loss of Always be sure that the tool is switched off and the •... -
Page 6: Reversing Switch Action
Reversing switch action Adjusting the fastening torque 1. Reversing 1. Graduations switch lever 2. Adjusting ring 3. Drill marking 4. Pointer 005219 005221 This tool has a reversing switch to change the direction The fastening torque can be adjusted in 17 steps by of rotation. -
Page 7: Screwdriving Operation
Use a cutting lubricant when drilling metals. The OPERATION exceptions are iron and brass which should be drilled dry. Screwdriving operation CAUTION: Pressing excessively on the tool will not speed up the • drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. - Page 8 Makita Corporation Anjo, Aichi, Japan 884535E223...