Maktec MT080 Instruction Manual
Cordless hammer driver drill
Hide thumbs
Also See for MT080:
- Instruction manual (56 pages) ,
- Instruction manual (49 pages) ,
- Instruction manual (25 pages)
Related Manuals for Maktec MT080
Summary of Contents for Maktec MT080
- Page 1 INSTRUCTION MANUAL Cordless Hammer Driver Drill MT080 MT081 011802 IMPORTANT: Read Before Using.
-
Page 2: Specifications
The vibration total value (tri-axial vector sum) determined In observance of European Directive according to EN60745: 2002/96/EC on waste electric and electronic equipment Model MT080 implementation in accordance with Work mode: impact drilling into concrete national law, electric equipment that Vibration emission (a ) : 8.5 m/s... -
Page 3: General Power Tool Safety Warnings
Designation of Machine: reduce risk of electric shock. Cordless Hammer Driver Drill Avoid body contact with earthed or grounded Model No./ Type: MT080,MT081 surfaces such as pipes, radiators, ranges and are of series production and refrigerators. There is an increased risk of Conforms to the following European Directives: electric shock if your body is earthed or grounded. - Page 4 will reduce personal injuries. taking into account the working conditions 12. Prevent unintentional starting. Ensure the and the work to be performed. Use of the power switch is in the off-position before connecting tool for operations different from those intended to power source and/or battery pack, picking could result in a hazardous situation.
-
Page 5: Functional Description
Do not touch the bit or the workpiece SAVE THESE INSTRUCTIONS. immediately after operation; they may be extremely hot and could burn your skin. Tips for maintaining maximum battery life Some material contains chemicals which may Charge battery cartridge before be toxic. -
Page 6: Speed Change
This tool has a reversing switch to change the direction of Battery protection system rotation. Depress the reversing switch lever from the A The battery cartridge is equipped with the protection side for clockwise rotation or from the B side for system, which automatically cuts off the output power for counterclockwise rotation. -
Page 7: Operation
For rotation only, turn the ring so that the arrow on the To remove the bit, hold the ring and turn the sleeve tool body points toward the mark on the ring. counterclockwise. For rotation with hammering, turn the ring so that the OPERATION arrow points toward the mark on the ring. -
Page 8: Drilling Operation
Place the point of the driver bit in the screw head and Drilling in metal apply pressure to the tool. Start the tool slowly and then To prevent the bit from slipping when starting a hole, increase the speed gradually. Release the switch trigger make an indentation with a center-punch and hammer at as soon as the clutch cuts in. - Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884991-227...