Icom IC-F6020 Series Instruction Manual page 9

HIGH/LOW KEY
Push to select the transmit output power temporarily or
permanently, depending on the presetting.
• Ask your dealer for the output power level for each selection.
C.TONE CH ENT KEY
Push to enter the continuous tone channel selection mode. Then,
push [CH Up]/[CH Down] to change the tone frequency/code
setting. The selected channel remains set as the continuous tone
channel until another channel is designated as such.
TALK AROUND KEY
Push to turn the talk around function ON or OFF.
• The talk around function equalizes the transmit frequency to the
receive frequency for transceiver-to-transceiver communication.
WIDE/NARROW KEY
Push to toggle the IF bandwidth between wide, mid* and
narrow.
• The wide passband width can be selected from 20.0 or 25.0 kHz
using the CS-F3020/F5010/F5020
operation only) Ask your dealer for details.
* Depending on the presetting, the mid width cannot be selected. Ask
your dealer for details.
DTMF AUTODIAL KEY
➥ Push to enter the DTMF channel selection mode. And
then select the desired DTMF channel using [CH Up]/
[CH Down].
➥ After selecting the DTMF channel, push again to transmit
the selected DTMF code.
. (PMR
cloning software
PANEL DESCRIPTION
RE-DIAL KEY
Push to transmit the last-transmitted DTMF code.
• TX memories are cleared after turning OFF the transceiver.
CALL KEYS
Push to transmit a 2/5-Tone ID code.
• Call transmission is necessary before calling another station
depending on your signalling system.
• [Call A] and/or [Call B] may can be selected when your system
employs selective 'Individual/Group' calls. Ask your dealer which
call is assigned to each key.
EMERGENCY KEY
Hold down this for specified period of time to transmit an
emergency call.
• The emergency call transmits with beeps; the display does not
change.
• The transceiver can transmit an emergency call without the beep
sounding and LCD indication change depending on the presetting.
Ask your dealer for details.
• If you want to cancel the emergency call, hold down the key again
before transmitting the call.
• The emergency call is transmitted one time only or repeatedly until
receiving a control code, depending on the presetting.
SURVEILLANCE KEY
Push to turn the surveillance function ON or OFF.
When this function is turned ON, the beep is not heard and
the LCD backlight does not light when a signal is received or
a key is pushed, and so on.
1
1
5