Table of Contents
Advertisement
Troubleshooting
Problem
The unit does not work.
"No link to base. Place
on cradle and try
again." is displayed and an
alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
The handset and/or base unit
does not ring.
The handset display is blank.
You cannot program function
items.
Previously programmed
information is erased.
44
Cause & Remedy
• Check the settings (p. 8–9).
• Check whether the dialing mode setting is
correct (p. 12).
• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again
(p. 9).
• Install the battery properly (p. 8).
• Place the handset on the base unit and
unplug the AC adaptor to reset it. Plug in, and
try again.
• Re-install the battery (p. 8) and charge it fully.
• You are too far from the base unit. Walk
closer and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
• Move the handset and the base unit away
from other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 19, 34).
• The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 16).
• When the handset is on the base unit, the
handset does not ring. Only the base unit
rings when receiving a call.
• Charge the battery fully (p. 8).
• Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• If a power failure occurs, programmed
information may be erased. Reprogram if
necessary.
Advertisement
Table of Contents
