Advertisement
2.Select the desired base and press the OK soft key. The handset begins searching the base.
3.Press the OK soft key after searching a base successfully.
4.Enter the base PIN (default: 0000), and then press the Done soft key to complete
registeration.
Note:
After the success of registration, the handset LCD screen prompts "Handset subscribed".
If the handset LCD screen prompts "Searching for Base", please check your base station
if powered on.
Network Settings
You can configure the base station to obtain network settings in one of the following ways:
DHCP: By default, the base station attempts to contact a DHCP server in your network to
obtain the valid network settings, e.g., IP address, subnet mask, gateway address
and DNS address.
Static IP Address: If the base station cannot contact a DHCP server for any reason, you need
to configure the IP address, subnet mask, gateway address, primary DNS
address and secondary DNS address for the base station manually.
PPPoE: If you are using an xDSL modem, you can connect your base station to the Internet
via PPPoE mode. Contact the ITSP for the account and password.
To configure the network parameters for the base station manually:
1.Press the OK key to enter the main menu, and then select Settings->System Settings ->Network.
2.Enter the system PIN (default: 0000), and then press the Done soft key.
3.Select the desired IP address mode from the IP Mode field.
4.Press
to select the corresponding IP address mode.
5.Make the desired changes.
6.Press the Save soft key to accept the change.
Note:
The IP DECT phone supports either or both IPv4 and IPv6 addresses mode, but IPv6 is
disabled by default.
Wrong network settings may result in inaccessibility of your DECT phone and may have
an impact on the network performance. For more information on these parameters,
contact your system administrator.
5
Advertisement
