Table of Contents
Advertisement
Automatically adjust clock for daylight saving
time changes
When you select it, the clock is automatically adjusted
according to the daylight saving time of the selected
time zone.
Note
If the time zone selected in Time zone is different from
that set on the computer, the time is adjusted using the
time zone difference and set on the camera.
Superimpose
Select whether to superimpose the camera ID and/or
date & time on the image or not.
The camera ID and/or date & time are also
superimposed on images recorded by the Pre-alarm or
Post-alarm function.
Camera ID
Checking this box allows you to superimpose the
camera ID. Enter a four-digit number for the camera ID.
Date & time
Checking this box allows you to superimpose the date
and time.
Style
Select the style of the superimposed item between
Border and Background.
Position
Select the position of the superimposed item from
among Top-left, Top-right, Bottom-left and Bottom-
right
Notes
• The superimposed camera ID and/or date & time area
is regarded as an inactive area of the object detection
function.
• A pale image may be viewed under the background of
the superimposed area.
• The size of the superimposed number is reduced if the
image size is set to 320 × 240 (QVGA).
• The superimposed number is not readable if the image
size is set to 160 × 120 (QQVGA).
• When you have changed the Date & Time setting,
click Refresh of the Web browser to reflect the change
on the opening main viewer.
OK/Cancel
See "Buttons common to every menu" on page 31.
36
Configuring the System — System Menu
Initialize Tab
Reboot
Reboots the camera.
Click Reboot, and the message "This Camera will be
rebooted. Are you sure?" appears. Click OK to reboot
the camera. It takes about two minutes to start again.
Factory default
Resets the camera to the factory settings.
Click Factory default, and the message "Setup data will
be initialized. Are you sure?" appears. When you click
OK, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
switch on the camera. For details, see the supplied
Installation Manual.
Backup setting data
Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera. The file name preset at the factory is "snc-
rx550.cfg."
Restore setting
Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Then, click OK, and the camera is adjusted
according to the loaded data and restarted.
Advertisement
Table of Contents
