Table of Contents
Advertisement
path: Type the command.
parameter: Type the command parameter if necessary.
You can use the special tags mentioned below for the
parameters.
Proxy server name
When you send HTTP request via a proxy server, type
the name or IP address of the proxy server, using up to
64 characters.
Proxy port number
Specify the port number when you send HTTP request
via the proxy server. Set a port number between 1024
and 65535.
Method
Select the HTTP method GET or POST.
OK/Cancel
See "Buttons common to every menu" on page 31.
About the special tags
You can use the following five special tags to allow
notification of the settings acquired by DHCP, such as an
IP address. Type the tags in the parameter section of the
URL that you described in the Message field of the
HTTP.
<IP>
Use this tag to embed the IP address acquired by DHCP
in the text or parameter.
<HTTPPORT>
Use this tag to embed the specified HTTP server port
number in the text or parameters.
<MACADDRESS>
Use this tag to embed the MAC address of the interface
whose IP address was acquired by DHCP, in the text or
parameter.
<MODELNAME>
Use this tag to embed the camera's model name in the
text or parameter.
<SERIAL>
Use this tag to embed the camera's serial number in the
text or parameter.
Using the 802.1X
Authentication Function
— 802.1X Menu
When you click
the 802.1X menu appears.
Use this menu to configure the wired or wireless port-
based authentication in compliance with the 802.1X
standard.
The 802.1X menu consists of three tabs: Common,
Client certificate and CA certificate.
Note
To use the 802.1X authentication function, you need
knowledge of the 802.1X authentication (WPA and
WPA2) and digital certificate. To establish an 802.1X
network, you need to configure the authenticator, access
point, authentication server and other elements. For
details on these settings, refer to the manual of the
corresponding equipment.
System configuration of 802.1X
network
The following figure shows a general system
configuration of an 802.1X network.
Supplicant
A supplicant is a device that connects to the
authentication server to join the network. This camera
serves as a supplicant in the 802.1X network. The
Using the 802.1X Authentication Function — 802.1X Menu
in the Administrator menu,
Supplicant (camera)
Authenticator (hub, router or
access point)
Authentication server + CA
49
Advertisement
Table of Contents
