Belt Switch (Switch Micro) - Asko TLS752 Manual

1. Function
• The switch cuts the power supply to the motor when a belt is
broken.
• The switch is on when the belt has adequate tension but off when
the belt gets loosened or broken, blocking the power supply to the
motor.
2. Specification
• Micro switch with two terminals, NC (normally closed) type
free state : COM and NO are connected
pushed down : COM and NC are disconnected
• Electric rating : 250V 16A 1/2HP
• Type name : GSM-V1622A2
3. Checking method of mal-function
• The switch is in normal operation if the drum rotates.
• Start the unit and check if the drum operates.
• If the drum fails to rotate, press the power button to stop the dryer and then again to check if the motor runs.
• If you can not hear the running of the motor, disassemble the dryer and check the belt switch contact.
• Press the lid of the belt switch. If the resistance between contacts is greater than 1, replace the belt.
Normal belt - switch lid free
Normal belt - switch lid free
Belt Switch
Belt Switch

Belt Switch (Switch Micro)

Damaged belt - switch lid pressed by the spring
Damaged belt - switch lid pressed by the spring
4. Procedure of replacement
① Plate Top remove
② Panel F Ass'y remove
③ Cabinet Front Ass'y remove
④ Frame Upper remove
⑤ Drum Ass'y remove
⑥ Check the position of the part.
⑦ Remove wires and 2 screws that fix the
switch.
⑧ Assemble the parts in reverse order.
56
Part Code : 3619047500