Table of Contents
Advertisement
Malfunction
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the wash
cycle.
The water is not
visible in the drum
bar.
Drum jerks after
program start.
Vibration and movement
of the appliance
during the spin
run.
Cause and Troubleshooting
was not pressed.
Press .
▶
The strainers in the water supply are clogged.
▶ Clean the strainers in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or pinched.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
may lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system provides an extra rinse when
foaming is too high.
No error - no action required.
▶
The water is below visible range.
No error - no action required.
▶
▶ Do not fill the device with additional water during
operation.
The cause is an internal motor test.
No error - no action required.
▶
The appliance is not leveled properly.
→ "Adjusting the device", Page 17
▶
Device feet are not fixed.
TroubleshootingNL
51
Advertisement
Table of Contents
