Table of Contents
Advertisement
NLService
Remark:To overwrite the saved
program, repeat the steps.
13.5 Filling the drum with
laundry
Remark:To avoid creasing, observe the
maximum load of the programs.
→ "Programs", Page 28
Requirements
sThe laundry is prepared and
sorted.
→ "Laundry", Page 32
sThe drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Make sure that no small items of
laundry are caught in the door.
13.6 Dosing detergent and care
agent
In programs where intelligent dosing
is not possible or desired, you can
dose the detergent manually.
Tip:In addition to the intelligent
dosing, you can also add other
detergents such as stain remover,
starch or bleach to the manual dosing
compartment. Do not add additional
detergent to the manual dosing
compartment to avoid overdosing or
foaming.
Remark:Keep the directions for
detergent and care agent → Page 33
at.
Pull out the detergent drawer.
1.
34
Fill with detergent.
2.
→
"Detergent drawer", Page 18
Fill with detergent if desired.
3.
Slide the detergent drawer into the
4.
appliance.
13.7 Starting the program
Required:A program is set.
→ "Set program", page 33
Press.
▶
aThe drum rotates and a
load recognition takes place, which
can take up to 2 minutes, after
which the water flows into the
device.
aThe display shows the program
duration function ready in time. a
After the program end, it shows
display:end.
13.8 Adding laundry
After the program has started, you
can remove or add laundry
depending on the program status.
Required:A program has started.
→ "Starting the program", Page
34
Press.
1.
The device pauses.
Remark:If you want to add laundry,
follow the instructions on the
display.
→ "Display", page 24
Open the door.
2.
Reload or remove the laundry.
3.
Close the door.
4.
Press.
5.
Advertisement
Table of Contents
