Raider RD-ESH01 User Manual page 20

20 www.raider.bg
Screwdriver
Rotate blade 180
°
When the two cutting edges of the blade are worn, they must be replaced as a pair. The blades can be
sharpened again, but this must be done by an experienced person. the weight of each knife is critical to
maintaining the balance of the blade. Any imbalance will cause vibrations that will cause damage to the
machine and possible injury to the operator.
12.6. TRANSHIPMENT PROTECTION
The unit automatically shuts off when the engine is overloaded, such as a blocked blade with thick
branches.
When the blade stops clogging, immediately press the interrupt start button to stop the machine and
remove the clog. This prevents overload protection from being activated.
12.7. ADJUSTING THE BOARD
Prior to initial use or if the crushing result is ineffective, the ejection plate must be properly adjusted
(see items - item 7). Setting up new machines may require adjusting the ejection plate at shorter intervals.
You will recognize when it is time to adjust the pusher plate when you see that the crushed material is only
crushed and does not separate properly.
13. GENERAL OPERATING INSTRUCTIONS
Hold the branches until they are pulled out automatically.
Follow the specified operating speed and do not overload the machine.
To prevent clogging, alternate soft garden waste and thinner branches with large branches.
Before crushing, remove any remaining soil and stones from the branches.
Do not cut soft or damp materials or kitchen waste.
Leave a few dry branches until the end of the work to use as a cleaning agent.
Switch off the machine after all material has passed through it.
When shredding, keep a safe distance from the machine as long branches can be thrown off sharply.
14. MAINTENANCE AND CLEANING
Repairs not specified in this manual may only be performed by an authorized service center. Only use
original spare parts. Use a pair of garden gloves (not supplied).
Before starting any maintenance work, stop the branch crusher, unplug it and wait until the knife stops
rotating before continuing.
14.1. GENERAL CLEANING AND MAINTENANCE
• Never spray the machine with water.
• Keep the unit, wheels and vents clean. Only clean with a brush or a soft cloth and never use harsh
cleaning agents or solvents.
• Check that all nuts, bolts and screws are tightened.
• Check the covers and protective equipment for damage and proper installation. Replace them if
necessary.
• Keep the device in a dry place and out of the reach of children.
• Do not cover the device with nylon as it may cause moisture.
14.2. STORAGE
• Keep the machine away from children.
• Turn off the engine and unplug the power cord if the machine is not in use.
• Allow machine to cool before storage.
• Do not store the machine in direct sunlight for long periods.
• Replace worn or damaged safety parts.
• Keep the machine in a clean, dry, dark and freezing place, protected from dust and out of reach of
children. The ideal storage temperature is between 5 and 30 ° C.
• Use original packaging for storage whenever possible.
• Cover the appliance with a suitable protective coating that does not retain moisture. Do not use
plastic as a protective coating. A pore-free coating will trap moisture around the machine, resulting
in rust and corrosion.
Remove 2 hex
headed screws
Hex spanner
Fig.10