Lifting The Unit - Generac Power Systems Magnum MLG8 Operating Manual

5. Check for proper inflation of the trailer tires. Refer to the Specifications beginning on
6. Check the wheel lugs. Tighten or replace any lugs that are loose or missing. If a
tire has been removed for axle service or replaced, tighten the lugs in the order
shown to the following specifications:
A. Start all lug nuts by hand.
B. First pass tighten to 20-25 ft-lbs (27-33 Nm).
C. Second pass tighten to 50-60 ft-lbs (67-81 Nm).
D. Third pass tighten to 90-120 ft-lbs (122-162 Nm).
Note: After the first road use, re-torque the lug nuts in sequence.
7. Maximum recommended speed for highway towing is 45 mph (72 km/h). Recommended off-road towing speed
is not to exceed 10 mph (16 km/h) or less, depending on terrain.

LIFTING THE UNIT

When lifting the unit, attach any slings, chains or hooks directly to the central lift point.
1. Make sure the equipment being used to lift the unit has sufficient capacity. For approximate weights, refer to
Specifications beginning on
2. Always remain aware of people and objects around the unit while moving.
3. Use the forklift pockets with care. Approach the unit as perpendicular as possible to avoid any damage to the
unit. Make sure any obstructions are clear of the forklift tines before lifting.
UNIT WITH STANDARD
FORKLIFT POCKETS
page 8.
UNIT WITH OPTIONAL
LIFT STRUCTURE
Central
Lift Point
page 8.
1
4 3
2
5
00204
Forklift
Pockets
00465
17