Table of Contents
Advertisement
Operation
Check the wheel lugs. Tighten or replace any lugs
6.
that are loose or missing. If a tire has been
removed for axle service or replaced, tighten the
lugs, in the order shown, to the following
specifications:
a.
Start all lug nuts by hand.
b.
First pass tighten to 20-25 ft-lbs
(27-33 Nm).
c.
Second pass tighten to 50-60 ft-lbs
(67-81 Nm).
d.
Third pass tighten to 90-120 ft-lbs
(122-162 Nm).
Figure 3-6. Lug Sequence
NOTE: After first road use, repeat tightening procedure.
Maximum recommended speed for highway towing is 45
mph (72 km/h). Recommended off-road towing speed is
not to exceed 10 mph (16 km/h).
Lifting the Unit
WARNING
Personal injury. Excessive weight. Use only
appropriate lifting eyes and lifting equipment to
lift unit. Improper lifting techniques could result in
equipment damage, death or serious injury. (000224)
When lifting the unit, attach any slings, chains or hooks
directly to the central lift point.
Verify the equipment being used to lift the unit has
1.
sufficient capacity. For approximate weights, see
the applicable product spec sheet.
Always remain aware of people and objects around
2.
the unit while moving.
12
002394
Use the forklift pockets with care. Approach the
3.
unit as perpendicular as possible to avoid
damaging the unit. Verify any obstructions are
clear of the forklift tines before lifting.
Figure 3-7. Standard Forklift Pockets
B
Figure 3-8. Optional Lift Structure
A
Forklift Pockets
B
Central Lift Point
Owner's Manual for Mobile Generator
003556
A
Advertisement
Table of Contents
