Table of Contents
Advertisement
Available languages
Available languages
Service and Adjustments
ALL MAINTENANCE AND REPAIR OPERATIONS NOT LISTED
MUST BE PERFORMED BY TRAINED SERVICE TECHNICIAN.
WARNING: Risk of unsafe operation. Unit cycles
automatically when power is on. When servicing, you may be
exposed to voltage sources, compressed air, or moving parts.
Before servicing unit unplug or disconnect electrical supply to
the air compressor, bleed tank of pressure, and allow the air
compressor to cool.
Additional Service
Disassembly or service of the air compressor beyond what is
covered in this manual is not recommended. If additional service
is required, contact your nearest Authorized Warranty Service
Center.
Accessories
Recommended accessories for use with your tool are available for
purchase from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please call
1-888-895-4549 or visit our website www.dewalt.com.
WARNING: The use of any other accessory not recommended
for use with this tool could be hazardous. Use only accessories
rated equal to or higher than the rating of the air compressor.
Service Information
Please have the following information available for all service calls:
Model Number ____________ Serial Number ___________
Date and Place of Purchase ____________________________
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be performed by a D
center, a D
WALT authorized service center or other qualified
e
service personnel. Always use identical replacement parts.
17
WALT factory service
e
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the DXCMSAC260 and is the answer not in the manual?
Questions and answers
I just purchased a Dewalt dxcmsac260 and whan it shuts off a valve opens and it start releasing the air pressure. it's the same valve that opens when I put the compressor in the off position. what can I do to stop this?
To stop the air pressure release from the valve when the DeWalt DXCMSAC260 shuts off, follow these steps:
1. Inspect for Leaks – Visually check air lines and fittings for any leaks.
2. Check the Safety Valve – Manually operate the safety valve by pulling on the ring. If it continues to leak, replace it.
3. Ensure Proper Shut-Off – Turn the Auto/Off switch to the "Off (O)" position.
4. Verify the Drain Valve – Ensure the drain valve is fully closed.
5. Check for Excessive Air Usage – Reduce air consumption if the compressor is overused.
6. Inspect the Hose – Look for any holes or damage in the hose and replace it if necessary.
7. Clean or Replace the Air Filter – If the intake filter is clogged, clean or replace it.
If the issue persists, contact a DeWalt service center.
This answer is automatically generated